Cervical Traction Unit - Bodyline Cervical Collars

• Easy to assemble
• Helps relieve cervical muscle spasms and tissue compression
• Helps relieve congestion and edema
• Stretches fibrotic tissues and adhesions
• Comes with the following:
  • 2 pulleys
  • 10 feet of traction chord
  • Spreader bar
  • Pulley arm
  • Door bracket
  • 20 lb. weight bag to hold water
  • Deluxe head halter
    • Adjustable chin strap made with white sateen on 3/8″ foam
    • Lined with nylon tricot
    • Open ear design avoids pressure over ears

• Cervical sprains, spasms, and strains
• Migraine headache
• Pinched Nerve
• Slipped Disc
• Soft Tissue Injury
• Swelling
• Tempromandibular Joint Disorder
• Whiplash
• Edema
• Other similar conditions

• Slide the pulley hooks over the ends of the V-wire to attach the pulley mechanism
• Attach the V-wire by aligning the notch on the large end of the V-wire with raised opening on the door bracket
• Slightly angle the door bracket upward to insert the notched V-wire
• While squeezing the V-wire, insert the short end of the V-wire into the hole of the bottom of the door bracket
• Position the assembled bracket over the top of an interior door

• Fill weight bag with the water and seal bag. Do not exceed over 20 lbs.
• Position bracket and pulley assembly over the to edge of door
• Tie one end of the traction cord to the metal bracket located at the top of the weight bag
• Make sure knot is secure
• Thread the loose end of the of the cord over both pulleys
• Tie the loose end of the traction cord to the closed end of the S-hook
• Hook the open end of the S-hook to the center hole on the notched spread bar
• Unfasten side straps of the head halter and slip head through the opening
• Side straps should hang down against the back
• Place chin on padded chin rest
• Rest head on back portion of halter and fasten side straps
• Side straps should reach underneath the ears and rest along the jaw
• Position a straight-back chair against door underneath bracket and pulley system (or stand facing door)
• Place the metal D-rings of the head halter into the notches located on either side of the spreader bar
• The various notches on the spreader bar provide various degrees of tension
• When done, unhook head halter from the spreader bar and remove halter
• Drain water from bags and open seal to allow bag to air dry
• Store bag flat or rolled after drying. Do not fold
• Head halter can be hand washed and line dried. Do not machine wash